Fujitsu PRIMERGY TX300 S4 Options Manual page 41

Accessible drives
Figure 21: Removing the dummy cover
Ê Press inward on the two metal tongues of the EasyClick rails (1) until the
locking mechanism disengages.
Ê Remove the dummy cover from the mounting bay (2).
Figure 22: UNC and M3 screws
Ê Detach the EasyClick rails from the dummy cover by removing the four
screws on each side.
I
Note that there are two M3 screws and two UNC screws on each side.
V
CAUTION!
Keep the dummy cover in a safe place. If you remove the accessible drive
again and do not replace it with a new one, the dummy cover must be
reinstalled to comply with EMC regulations and to satisfy cooling require-
ments and fire protection measures.
TX300 S4
UNC screw
(large screw head)
Options Guide
Installing an accessible 5.25-inch drive
1
2
1
M3 screw
(small screw head)
41