Replacing The Heat Sink - Fujitsu PRIMERGY TX300 S4 Options Manual

Processors
9.3

Replacing the heat sink

Ê Open the server as described on
page 24 for the rack model.
Ê Remove the air duct (see on
Ê Remove the system fan (see on
Ê Remove the heat sink holder (see on
Ê Loosen the four screws of the heat sink in a crossover pattern (see on
page 80).
Ê Loosen the heat sink by turning it back and forth and then lift it out.
Ê Clean the upper side of the processor using a lint-free cloth.
Ê Remove the protective cover from the new heat sink (see
Ê Place the heat sink on the processor socket (see
Ê Fasten the heat sink by tightening the four screws in a crossover pattern.
Ê Reinstall the system fan (see
Ê Reinstall the heat sink holder (see on
Ê Reinstall the air duct (see
Ê Close the server, connect it to the power outlet, and switch it on as described
on page 118 for the floorstand model or on
TX300 S4
page 21 for the floorstand model or on
page 28).
page 29).
page 74)
page 113).
page 79)
page 115).
page 120
Options Guide
Replacing the heat sink
page 77).
page 78).
for the rack model.
83