Performing Distance Correction During Cutting
Procedure
MENU
CUTTING MENU
CUTTING MENU
CALIBRATION
FEED SETTING
0.00%
0.00%
CALIBRATION
SCAN SETTING
SCAN SETTING
0.00%
0.00%
W 736mm
SETUP SHEET
ROLL
Description
The movement distance for the media changes subtly depending on the media's thickness. This means
that the length of a line when cut may differ from the length setting in the data. You enter a correction
value when you want to align the lengths of cut lines precisely.
When performing printing followed immediately by cutting, be sure to set this to "0.00."
Default Setting
[FEED SETTING]: 0.00%
[SCAN SETTING]: 0.00%
5-5 Optimizing Printing to Match Media Thickness
Press
.
Press
several times.
Press
.
Press
twice.
Press
twice.
Use
rection value.
Press
to enable the setting for [FEED SET-
TING].
Press
.
Press
.
Press
.
Use
rection value.
Press
to enable the setting for [SCAN SET-
TING].
Press
.
Press
to go back to the original screen.
Chapter 5 Feature Reference
to make the setting for the cor-
to make the setting for the cor-
113