5-5 Optimizing Printing to Match Media Thickness
Adjusting Head Height to Match Media Thickness
Procedure
MENU
HEAD HEIGHT
HEAD HEIGHT
LOW
Open the front cover.
Move the lever to adjust the height of the head.
Moving the lever to "HIGH" makes a warning beep sound twice. Moving it to "LOW" makes the
warning beep sound once.
Height-adjustment lever
Move firmly, until it stops.
MENU
HEAD HEIGHT
W 736mm
SETUP SHEET
ROLL
Description
Depending on the media, the media may be thick, or may wrinkle or come loose from the platen dur-
ing printing, increasing the chance of contact with the print heads. When you're using such media, set
[HEAD HEIGHT] to "HIGH."
Printing quality when [HEAD HEIGHT] is set to "HIGH" may be coarser or otherwise lower than when
set to "LOW." If this happens, refer to the pages indicated below.
P. 95, "Preventing Soiling of the Media and Dot Drop-out During Printing," p. 107, "Correcting for Misalignment
106
Chapter 5 Feature Reference
Press
Press
Press
LOW
HIGH
LOW
Close the front cover.
The print heads return to their original position and the screen
shown in the figure appears.
Press
Press
.
several times.
.
HIGH
LOW
Height-adjustment lever
Move firmly, until it stops.
.
to go back to the original screen.