Performing Distance Correction During Cutting - Roland VersaUV LEC-300A User Manual

5-5 Optimizing Printing to Match Media Thickness

Performing Distance Correction During Cutting

Procedure

MENU
CUTTING MENU

CUTTING MENU
CALIBRATION

FEED SETTING
0.00%

CALIBRATION
SCAN SETTING

SCAN SETTING
0.00%

W 736mm
SETUP SHEET
ROLL
Description
The movement distance for the media changes subtly depending on the media's thickness. This means
that the length of a line when cut may differ from the length setting in the data. You enter a correction
value when you want to align the lengths of cut lines precisely.
When performing printing followed immediately by cutting, be sure to set this to "0.00."
Default Setting
[FEED SETTING]: 0.00%
[SCAN SETTING]: 0.00%
112
Chapter 5 Feature Reference
Press
Press
Press
Press
Press
0.00%
Use
rection value.
Press
TING].
Press
Press
Press
0.00%
Use
rection value.
Press
TING].
Press
Press
.
several times.
.
twice.
twice.
to make the setting for the cor-
to enable the setting for [FEED SET-
.
.
.
to make the setting for the cor-
to enable the setting for [SCAN SET-
.
to go back to the original screen.