Roland LEC-300A User Manual page 172

7-5 Specifications
Environment
Accessories
*1
The length of printing or cutting is subject to the limitations of the program.
*2
With Roland PET film, print travel: 1 m
Temperature: 25°C (77°F),relative humidity: 50%
*3
The following conditions must be met:
 Media type: Media specified by Roland DG Corp.
 Roll media must be loaded on the shaft.
 [PREFEED] menu item must be set to "ENABLE."
 Side margins: 25 mm or more for both the left and right margins
 Front margin: 35 mm or more
 Excluding expansion/contraction of the media
Range for assured repetition accuracy
 Length 3,000 mm
*4
 Provided that media length is under 3,000 mm
 Temperature: 25°C (77°F)
 Excluding possible shift caused by expansion/contraction of the media and/or by reloading the
media.
*5
 Media type : Roland PET film
 Data size: 1,000 mm in the media-feed direction, 736 mm in the carriage-movement direction
 No lamination
 Automatic detection of crop marks at 4 points when media is reloaded.
 During cutting, [PREFEED] menu item must be set to "ENABLE."
 Temperature: 25°C (77°F)
 Excludes the effects of slanted movement and of expansion and contraction of the media.
*6
During operation of the media take-up system, an operating range of approximately 80 millimeters
back from the front edge of the dancer roller is required.
170
Chapter 7 Specifications
Power on
Power off
Temperature: 20 to 32ºC (68 to 90ºF) (22ºC [72˚F] or more
recommended) , Relative humidity: 35 to 80% (no conden-
sation)
Temperature: 5 to 40˚C (41 to 104˚F), Relative humidity: 20
to 80% (no condensation)
Exclusive stands, power cord, blade, blade holder (XD-CH2),
media clamps, replacement blade for separating knife, clean-
ing kit, software RIP (Roland VersaWorks) , User's Manual,
etc.