Roland LEC-300A User Manual page 130

5-7 Performing Printing and Cutting Separately
5.
From the test pattern, read the correction value at the location.
Test pattern
Correction-value scale
Check the value on
the [FEED] side.
6.
Enter the correction value you read.

CROP - CUT ADJ.
SETTING

F :- 0.30
S : 0.00

CROP - CUT ADJ.
SETTING
7.
Check the results of adjustment.
CROP - CUT ADJ.
SETTING
Cutting position and printing position are aligned.
128
Chapter 5 Feature Reference
Press
Press
- 0.30mm
- 0.20mm
Use
(the feed direction).
Use
(the scanning direction).
Press
Press
Press
Press
If the printing and cutting lines are aligned, adjustment is
complete.
If further adjustment is needed, go back to step
tune the adjustment.
Cutting position
Printing position
Check the value on
the [SCAN] side.
Scan direction
The point where the cutting line
intersects the correction-value
scale is the correction value. In this
Cutting line
figure, the value is "-0.3." Use the
same method to read the value on
the [FEED] side.
.
.
to set the correction value for [F]
to set the correction value for [S]
to enable the setting.
.
.
to execute.
Cutting line
6.
and fine-