Roland LEC-300A User Manual page 162

6-8 If an Error Message Appears
[SHEET TOO SMALL CONTINUE?]
The size of the data is larger than the print-
ing or cutting area of the loaded media.
To continue performing output without correcting
this, press
ing beyond the printing or cutting area is not output.
To stop output, stop sending data from the computer,
then hold down
Make the printing or cutting area wider, such as by
replacing the media with a larger piece of media or
by changing the positions of the pinch rollers, then
send the data again.
[SHEET SET ERROR SET AGAIN]
was pressed even though no media
is loaded.
Press any key to clear the error. Load media and pull
back the loading lever, then press
[EDGE DETECTION] is set to "ENABLE," but
transparent media was loaded.
Raise the loading lever, set the [EDGE DETECTION]
menu item to "DISABLE," then reload the media.
 P. 93, "Using Transparent Media"
The loaded media is too small.
Press any key to clear the error. Replace with media
of usable size.
[HEAD HEIGHT ERROR]
The height-adjustment lever for the print
heads was operated improperly.
Operation cannot be continued. Switch the sub
power off, then back on. To change the head height,
use the [HEAD HEIGHT] menu.
 P. 106, "Adjusting Head Height to Match Media Thick-
ness"
[TEMPERATURE IS TOO LOW **°C]
The temperature of the location where the
machine is installed has fallen below the
ambient temperature at which the machine
160
Chapter 6 What to Do If
. At this time, the portion extend-
for one second or longer.
can operate.
Operation cannot be continued. Switch off the sub
power. The displayed temperature is the current
ambient temperature of the installation location.
Bring the installed location to a temperature at
which operation is possible (20 to 32°C) and allow
the machine to come to room temperature, then
turn on the power.
[DATA ERROR CANCELING...]
Output was stopped because a problem was
found in the data received.
Operation cannot be continued. Check whether the
data contains errors. Also, check for a problem with
the connector cable or the computer, and redo the
operation from the step of loading the media.
[PINCHROLL ERROR LOWER PINCHROLL]
.
was pressed without first lowering
the pinch rollers.
Press any key to clear the error. Pull back the loading
lever, then press
The pinch rollers were raised while
was illuminated.
The error is cleared automatically after a short wait.
Never move the loading lever while printing is in
progress.
[PINCHROLL ERROR INVALID RIGHT
POS]
The right pinch roller is positioned at a loca-
tion where it does not pinch the media.
Raise the loading lever and move the right pinch
roller to the correct location.
 P. 42, "Cutting Off the Media"
[PINCHROLL ERROR INVALID LEFT POS]
The left pinch roller is positioned at a loca-
tion where it does not pinch the media.
Raise the loading lever and move the left pinch roller
to the correct location.
 P. 35, "Loading and Cutting Off Media"
.