Part Names And Functions; Printer Unit - Roland LEC-300A User Manual

1-2 Part Names and Functions

Printer Unit

Front cover
Be sure to close this when
you perform printing.
Maintenance cover
You remove this when you
perform cleaning of the
print heads.
Media discharge port
Stiff media is discharged
here.
Media guide
This prevents the end of the
media from striking the stays
or other areas, which can cause
the media to come loose.
Main power switch
Power-cord connector
This supplies power to the
printer.
Cartridge slots
There are where ink cartridges
are installed.
26
Chapter 1 Introduction
Side cover
You remove this when you
perform maintenance.
Drain bottle
This collects drained ink
and other such fluids.
Rear cover
Be sure to install this when
performing printing.
Media discharge port
Media is normally discharged here.
Air-intake port
This is where air intake is performed to lessen the charac-
teristic odor of ECO-UV inks. A deodorizer must be provided
separately.
 "Setup guide"
Link LED
This lights up green when the connection
to the network is correct.
Status LED
This flashes yellow while data is being re-
ceived from the network.
Ethernet connector
This is used to connect the printer to a
network.
Shaft
Stopper
Loading lever
You operate this when you
load media.
Operation panel
You use this to perform
various operations.

P. 28, "Operation Panel"
Brake
This helps to ensure
stable media feed.