Making the Setting for Blade Force
Procedure
FORCE
50gf
60gf
W 736mm
SETUP SHEET
ROLL
Pressing
enters the cutting configuration menu. You can also make the settings for other cut-
ting conditions in addition to the blade force. Refer to the following pages.
P. 114, "Fine-tuning the Cutting Conditions"
When you're finished making all the settings, send cutting data from the computer.
P. 44, "Getting Ready to Receive Data from a Computer"
Press
.
Use
Press
to finish making the setting, and go
back to the original screen.
2-6 Performing Cutting
to enter the value.
Chapter 2 Basic Operation
Chapter 2 Basic Operation
53