Roland LEC-300A User Manual page 49

LEC-330
CLEANING...
>>
NORMAL CL.
A C

W 736mm
SETUP SHEET
ROLL

Perform a printing test again to make sure the dot drop-out has been cor-
rected.
If the problem persists, try performing cleaning a second time.
If the problem doesn't go away even after performing cleaning two or three times, then try
cleaning using a different method.
 P. 67, "When Head Cleaning Is Not Effective"
If the Printing-test Results Are Difficult to Interpret
Examine the results from different angles in a well-lighted location. Take advantage of
reflected light to enable visual checking. We recommend performing the printing test
on transparent or silver-colored media.
When you want to clean all heads simultaneously
Hold down
cally.
Press
Cleaning starts.
When it finishes, the screen shown in the figure appears
again.
Press
Press
for one second or longer. Cleaning for all heads starts automati-
2-4 Starting Printing
.
.
to go back to the original screen.
Chapter 2 Basic Operation
47