Preventing Pulling Of The Media With Undue Force When Performing Cutting Only - Roland LEC-300A User Manual

Description
Hardened ink is thick. This means that the cutting conditions when you're cutting a printed surface
are different from the cutting conditions when you're cutting a surface that hasn't been printed. When
you're cutting a printed surface, use this [CUT TEST PRINT] to adjust the cutting conditions.
Note: These adjustments are general suggestions. Their accuracy is not assured.

Preventing Pulling of the Media with Undue Force When Performing Cutting Only

Procedure

MENU
CUTTING MENU

CUTTING MENU
PREFEED

PREFEED
DISABLE ENABLE

W 736mm
SETUP SHEET
ROLL
Description
When you're performing cutting only, it may be convenient to set this feature to "ENABLE." This feeds
out media according to the size of the data sent from the computer before performing cutting. This
makes it unnecessary to turn the media flanges by hand to feed out media every time you perform
cutting. Note, however, that this feeds out media even when you're performing printing only, so set it
to "DISABLE" when not needed.
5-6 Making Various Adjustments for Cutting
Press .
Press several times.
Press .
Press several times.
Press .
Use
Press to enable the setting.
Press .
Press to go back to the original screen.
Chapter 5 Feature Reference
to select "ENABLE."
119