Performing Distance Correction During Cutting - Roland VersaUV LEC2-300 User Manual

Accurately Adjusting the Cutting Settings

Performing Distance Correction during Cutting

This correction is performed when you want to accurately align the lengths of cut lines when cutting. This setting is
also applied during cutting only, printing and cutting, or cutting with crop marks.
The movement distance of the media changes subtly depending on the media's thickness. This means that the
length of a line when cut may differ from the length setting in the data.
Procedure
1.
Press [MENU].
2.
Press [▲] to display the screen shown below.
MENU
CUTTING MENU
3.
Press [▶] once, and then press [▼] several times to display the screen shown below.
CUTTING MENU
CALIBRATION
4.
Press [▶] twice to display the screen shown below.
FEED SETTING
0.00%
5.
Press [▲] or [▼] to select the correction value.
Set the correction value of the media feed direction.
FEED SETTING
0.00%
6.
Press [ENTER] to confirm your entry.
7.
Press [◀], then [▼] to display the screen shown below.
CALIBRATION
SCAN SETTING
8.
Press [▶] to display the screen shown below.
SCAN SETTING
0.00%
9.
Press [▲] or [▼] to select the correction value.
Set the correction value of the cutting carriage movement direction.
10.
Press [ENTER] to confirm your entry.
11.
Press [MENU] to go back to the original screen.
MEMO
Default settings
• FEED SETTING: 0.00%
• SCAN SETTING: 0.00%
136
1. Optimizing the Output Quality
0.00%
-0.10%
0.00%