Ricoh S-C4.5 Field Service Manual page 82

4. Replacement and Adjustment
4
5. Slide the 1st and 2nd scanners so that all four of the following are roughly aligned on both the front
and back sides:
• The hole in the copier's lid
• The hole in the 1st scanner
• The right corner hole in the 2nd scanner
• The hole at the base of the scanner
6. Insert the two optics adjustment tools [A], and adjust the scanners as necessary so that the tools go
through all four holes.
7. Tighten the two screws that you loosened at step 2 above, so that the belts are firmly clamped into
place.
8. Remove the adjustment tools.
80