Ricoh S-C4.5 Field Service Manual page 66

2. Installation
3. Input a machine serial number with SP 5811-001.
4. Go into the SP mode and push "EXECUTE" with SP5-878-001.
5. Select SP5878-002, and then press "Execute" on the LCD.
6. Exit the SP mode after "Completed" is displayed on the LCD.
2
Activating the Security Applications
1. Make sure that the following settings are not at their factory default values:
• Supervisor login password
• Administrator login name
• Administrator login password
If any of these settings is at a factory default value, tell the customer these settings must be changed
before you do the installation procedure.
2. Make sure that "Admin. Authentication" is ON.
[System Settings] – [Administrator Tools] – [Administrator Authentication Management] - [Admin.
Authentication]
If this setting is OFF, tell the customer this setting must be ON before you do the installation procedure.
3. Make sure that "Administrator Tools" is enabled (selected).
[System Settings] – [Administrator Tools] – [Administrator Authentication Management] - [Available
Settings]
If this setting is disabled (not selected), tell the customer this setting must be enabled (selected) before
you do the installation procedure.
4. Refer to the Security Reference for details about activating the security applications (HDD Encryption
Unit and DataOverwriteSecurity).
HDD Encryption Recovery from a Device Problem
The flowchart below shows the recovery possibility of the HDD encryption if one of devices related with
the HDD encryption is defective.
64