2. Installation
2
1. Remove the I/F-slot cover [A] (
2. Install the Gigabit Ethernet board (Knob-screw x 2) into the I/F-slot [B].
3. Attach one ferrite core [A] to the Ethernet interface cable, and then attach the other ferrite core [B]
about 10cm from the end of the Ethernet interface cable.
4. Connect the Ethernet interface cable to the Gigabit Ethernet port.
Make sure that the machine can recognize this option (see 'Check All Connections' at the end of this
section).
60
x 2).