Ricoh S-C4.5 Field Service Manual page 361

7 Not used
System Switch 01 - Not used (Do not change the factory settings.)
System Switch 02 [SP No. 1-101-003]
No FUNCTION
0-1 Not used
Force after transmission stall
2 0: Off
1: On
3-5 Not used
Memory read/write by RDS
Bit 7: 0, Bit 6: 0
Always disabled
Bit 7: 0, Bit 6: 1
6-7 User selectable
Bit 7: 1, Bit 6: 0
User selectable
Bit 7: 1, Bit 6: 1
Always enabled
System Switch 03 [SP No. 1-101-004]
No FUNCTION
Length of time that RDS is
temporarily switched on when bits 6
0-7
and 7 of System Switch 02 are set
to "User selectable"
System Switch 04 [SP No. 1-101-005]
Do not change the setting.
COMMENTS
Do not change these settings.
With this setting on, the machine resets itself automatically
if a transmission stalls and fails to complete the job.
Do not change these settings.
(0,0): All RDS systems are always locked out.
(0,1), (1,0): Normally, RDS systems are locked out, but the
user can temporarily switch RDS on to allow RDS operations
to take place. RDS will automatically be locked out again
after a certain time, which is stored in System Switch 03.
Note that if an RDS operation takes place, RDS will not
switch off until this time limit has expired.
(1,1): At any time, an RDS system can access the machine.
COMMENTS
00 - 99 hours (BCD).
This setting is only valid if bits 6 and 7 of System Switch 02
are set to "User selectable".
The default setting is 24 hours.
Bit Switches
5
165