Startup Display And Display Elements; Startup Display - Omron FQ2-S Series User Manual

1-4 Startup Display and Display Elements

FQ2-S1 FQ2-S2

Startup Display

1
When the Sensor and Touch Finder are powered on,
the language selection display appears and then the
Sensor List.
Select the Sensor you want to connect, and press [OK].
2
Sensor connection processing takes place.
3
If the Sensor is not detected, press the [Sensor List]
button to move to the Sensor List, and check the con-
nection settings.
Selecting the Sensors to Connect: p.266
Note
In the following cases, the Sensor List will not appear.
• The Sensor to be connected is already set
• "Auto sensor detection" is set to ON
• "Specify sensor" is set to ON
4
When the Sensor is detected, the following display will appear.
• The Setup Mode will appear if a Sensor that has not been
set up is connected.
• The Run Mode will appear if a Sensor that has been set
up is connected.
Note
When the Touch Finder is started, IP addresses are automatically set for each Sensor.
To allocate specific IP addresses, set the IP address of each Sensor and the Touch Finder.
2-5 Setting Up Ethernet: p.59
28

Startup Display and Display Elements

FQ2-S3 FQ2-S4 FQ2-CH
FQ2-S/CH User's Manual