Setting The Startup Run Display Pattern; Specifying The Sensors To Connect Continuously; Monitoring And Setting Up A Sensor From Two Touch Finders - Omron FQ2-S Series User Manual

Setting the Startup Run Display Pattern

You can select the startup run display pattern. This only appears when [Start screen type] under [Startup
display] is set to [Single sensor].
(Setup Mode or Run Mode) − [TF settings] − [Startup display] − [Display pattern]
1
Select from the following: [Graphics], [Graphics + Details], [Statistical data], [All results/region],
[Trend monitor], or [Histogram].
Note
The default display setting for startup can be changed.
Selecting the Display When More Than One Sensor Is Connected: p. 267

Specifying the Sensors to Connect Continuously

You can specify one Sensor to connect to the Touch Finder.
The Touch Finder will connect to that Sensor each time the Touch Finder is started.
(Setup Mode or Run Mode) − [TF settings] − [Startup display]
1
Set [Specify sensor] to [ON].
2
Set [Sensor selection] to the IP address of the Sensor.
Note
If the Touch Finder cannot connect to the specified Sensor when the Touch Finder is started, it will continue to retry
until a connection is made.
If connection to the specified Sensor is not possible, press the [Sensor List] Button to cancel connecting to the spec-
ified Sensor.

Monitoring and Setting Up a Sensor from Two Touch Finders

You can monitor and set up the same Sensor from two Touch Finders.
You can simultaneously monitor the Sensor from both Touch Finders.
You can set up the Sensor only from one of the two Touch Finders at any one time.
Touch Finder
Switching Hub
You can monitor the same Sensor at the same time from a locally installed Touch Finder
and a remotely installed Touch Finder.
FQ2-S/CH User's Manual
Touch Finder Sensor
Convenient Functions for Operation
285