Unstable Labeling Results - Omron FQ2-S Series User Manual

Step 3 Adjusting Judgement Parameters
− [Inspection]
[Inspect]
1
Press [Judgement].
2
Press the parameters and set the OK ranges.
Set the range for each of the following parameters. Con-
tinuous measurements will be performed for the images
that are taken.
Note
You can change the parameters for judgement conditions on the
Display Settings Display. Press
of the display to switch to the Display Settings Display.
3
Press [OK] to accept the value.
Item Parameter
Judgment Number of
parameters labels
Total label area Range: 0 to 999,999,999.9999
Area
Gravity center
X
Gravity center
Y
Master angle

Unstable Labeling Results

The Desired Color Cannot Be Detected
Add a specific color or enlarge the color range.
206
Inspecting with the Labeling Inspection Item
− [Add item.] − [Labeling] − [Settings] Tab Page
− [Display setting] on the right
[ ]
Setting
Range: 0 to 100
Defaults: Upper limit: 100, Lower limit: 0
Defaults: Upper limit: 999,999,999.999,
Lower limit: 0
Range: 0 to 999,999,999.9999
Defaults: Upper limit: 999,999,999.999,
Lower limit: 0
Range: −99,999.999 to 99,999.999
Defaults: Upper limit: 99,999.999,
Lower limit: −99,999.999
Range: −99,999.999 to 99,999.999
Defaults: Upper limit: 99,999.999,
Lower limit: −99,999.999
Range: −180 to 180
Defaults: Upper limit: 180, Lower limit: −180
If more than one result was detected,
you can switch to a display for each result.
Upper limit
Blue for OK. Red for NG.
Description
Set the upper and lower limits of the number of labels for
an OK judgement.
Set the upper and lower limits of the total label area for
an OK judgement.
Sets the upper and lower limits of the area for an OK
judgement.
Set the upper and lower limits of the gravity X for an OK
judgement.
Set the upper and lower limits of the gravity Y for an OK
judgement.
Sets the upper and lower limits of the master angle for an
OK judgement.
FQ2-S/CH User's Manual
Lower limit