Connecting To Sensors From External Devices Such As Plcs; Connecting To Sensors From A Computer Using The Pc Tool - Omron FQ2-S Series User Manual

Connecting to Sensors from External Devices Such as PLCs

Set the IP address of the Sensor according to the network where the external devices, such as PLCs, are
connected.
(Setup Mode) − [Sensor settings] − [Network] − [Ethernet] − [IP address setting]
1
Press [Fixed].
2
Set the IP address and subnet mask according to the network where the external devices, such
as PLCs, are connected.
Note
If you connect OMRON CS/CJ-series PLCs to the Ethernet, the following default IP addresses are assigned to the
PLCs.
• IP address: 192.168.250.node_address

Connecting to Sensors from a Computer Using the PC Tool

Configurations Consisting of Only Sensors and a Computer (PC Tool)
If the configuration consists only of Sensors and a Touch Finder, set the network settings on the computer as
described below.
(No IP address settings are required on the Sensors.)
The following procedure is for Windows 7.
1
Select [Control Panel] from the Windows Start.
2
Click [Network and Internet] on Control Panel.
3
Click [Network and Sharing Center].
4
Click [Change adapter settings] on the left side of [Net-
work and Sharing Center].
5
Click the [Local Area Connection] icon in the Network
connection window.
60
Setting Up Ethernet FQ2-S/CH User's Manual