Setup Procedure for Bar Code
Step 1
Selecting the Inspection Item
−
[Inspect]
[Inspection]
1
Press an unused inspection item number and press
[Add item.].
2
Press [Bar code].
4-3 Configuring Inspection Items: p. 106
Note
Drag the arrow (
the inspection items.
Step 2
Teaching
Step 3 Verification Conditions
For teaching, the region to measure and the barcode within that region are set as read conditions.
You can also register the contents that was read from the barcode as a verification condition in the master data.
−
[Inspect]
[Inspection]
1
Press [Teach].
2
Input an image of the barcode.
3
Move the rectangle so that it surrounds the barcode.
4
Press the [OK] Button.
5
Press [TEACH] on the lower right of the display.
6
The result of reading the barcode that was displayed
will be displayed along with a confirmation dialog
box for registration in the master data.
7
Press [Yes] to register the barcode read result in the
master data.
The master data contains the character strings from the
barcodes that are registered to verify whether the read
character strings match specific character strings.
8
Press the master data in which the read characters
will be registered.
9
Press [Back] to end teaching.
124
Reading Bar Codes
) at the bottom of the menu to display all of
−
−
[Add item.]
[Bar code]
−
[Settings] Tab Page
Drag the rectangle
to move it.
Drag a corner to size
the rectangle.
FQ2-S/CH User's Manual