Setup Procedure For 2D-Code - Omron FQ2-S Series User Manual

Setup Procedure for 2D-code

Step 1 Selecting the Inspection Item
[Inspect] − [Inspection]
1
Press an unused inspection item number and press
[Add item.].
2
Press [2D-code].
4-3 Configuring Inspection Items: p. 106
Note
Drag the arrow (
the inspection items.
Step 2 Teaching
For teaching, the region to measure and the 2D code within that region are set as read conditions. You can also
register the contents that was read from the 2D code as a verification condition in the master data.
Step 3 Verification Conditions: p. 133
[Inspect] − [Inspection] − [Add item.] − [2D-code] − [Settings] Tab Page
1
Press [Teach].
2
Input an image of the 2D code.
3
Move the rectangle so that it surrounds the 2D code.
4
Press the [OK] Button.
5
Press [TEACH] on the lower right of the display.
6
The result of reading the 2D code that was displayed
will be displayed along with a confirmation dialog
box for registration in the master data.
7
Press [Yes] to register the read result in the master
data.
The master data contains the character strings from the
2D codes that are registered to verify whether the read
character strings match specific character strings.
8
Press the master data in which the read characters
will be registered.
9
Press [Back] to end teaching.
132
Reading 2D-codes
) at the bottom of the menu to display all of
FQ2-S/CH User's Manual