Table of Contents
Advertisement
Sample display:
$ PUTD
Target Port for Debug : * *
$
[1] DTMF:3
[1] DTMF:8
[1] A.Attend
[1] DTMF:#
[1] DTMF:6
[1] Voice Mail
[1] DTMF:1
[1] DTMF:0
[1] DTMF:1
[1] NonSub Svc
[1] * * *
[1] DTMF:#
[1] DTMF:9
[1] Thank you
WARNING
"PUTD" is a command originally used when troubleshooting. Do not use
this command for any other purpose. Do not disconnect the RS-232C
connection while the "PUTD" command is enabled. This could cause data
overflow.
7.2.20 Wait for Caller ID (WCID)
Use the WCID command to specify the length of time (in seconds) the VPS must wait for the
Caller ID after the VPS has received the incoming call from the PBX.
If Caller ID is not needed at all, set the waiting time to "0" to accelerate the VPS response to
incoming calls.
Type WCID, then Press RETURN.
$ WCID
WAIT TIME FOR CALLER ID (5 sec) [0-60 sec] : = 0
$
7.2.21 Turn off System/User Prompt (TURN)
Use the TURN command to turn off specific System/User prompts, or to display the numbers
of the currently turned-off prompts.
Type TURN, Press Space, Enter the prompt type (0: System Prompts, 1: User 1 Prompts,
7.2 UTILITY COMMANDS
Installation Manual
203
Advertisement
Table of Contents
Troubleshooting
