Panasonic KX-TVS95 Installation Manual page 263

Table B-4
Parameter
Use Mode
No. of
Retries
Busy Delay
Time
No Answer
Delay Time
Time Frame
1, 2
MON:
TUE:
WED:
THU:
FRI:
SAT:
SUN:
Remote Call Forward to CO
Follow the procedure below to specify the destination outside telephone number(s) to which
the callers are forwarded when the Remote Call Forwarding feature is set to an outside (CO)
line.
Telephone number 1 and Telephone number 2 can be specified per mailbox.
• Class of Service programming determines if the mailbox owner is able to use this
feature.
• This feature is only available with DPT Integration.
To access the menu for Remote Forward to CO, follow the menu path as shown:
System Administration Top Menu-1-1-1-Mailbox No.-3-Telephone Number 1 or
2.
Value Range
(Default)
1. Not Use Specifies how Device 1, 2, or 3 is to be used. The
2. Continuously subscriber can also specify the use mode from his
3. Scheduled telephone.
(Continuously)
1. Not Use—Device 1, 2, or 3 is not used for a
notification call.
2. Continuously—Device 1, 2, or 3 is called whenever
a message is recorded in the mailbox.
3. Scheduled—Device 1, 2, or 3 is called on a schedule
basis when a message has been left in the mailbox.
0-9 times Specifies the number of times that a notification call to
(0) Device 1, 2, or 3 should be attempted after a busy or no
answer condition is received.
0-120 min Specifies the time (in minutes) the VPS must wait after a
(3) busy condition is received before making another
notification call to Device 1, 2, or 3.
60-120 min Specifies the time (in minutes) the VPS must wait after a
(60) no-answer condition is received before making another
notification call to Device 1, 2, or 3.
1-12: h Specifies the daily schedule for the Message Waiting
Notification service for 1 week for this device.
00-59: min
AM/PM:
Note
a.m./p.m.
: All Day
Space: No Use
(No Use)
B2 SYSTEM ADMINISTRATION—MAILBOXES
Description/Function
These parameters are active only when "Use Mode"
is set to "Scheduled".
Installation Manual 263