Panasonic KX-TVS95 Installation Manual page 103

4.4 KX-TDA/KX-TAW SERIES PROGRAMMING FOR DIGITAL INTEGRATION
Screen output:
Note
The above screen output is an example of the KX-TDA200.
5.
Connect the jack assigned in Step 3 to the VPS.
6.
Connect your personal computer to the VPS and start your communication software (i.e.,
HyperTerminal, Procomm Plus, Smartcom...).
Communication Parameters: 9600, 8 Bit, None, 1
7.
Disconnect the power from the VPS and set the DIP switch on the VPS to position 5.
Only perform this step when initially setting up the system.
CAUTION
Setting the DIP switch to position 5 will default the Voice Processing System,
resulting in a loss of all user programming, and voice messages (except User 1 and
User 2 prompts).
8.
Plug in and power up the VPS and wait approximately 3.5 min while the system initializes.
"System Administration" Start-Up Sequence
Before starting the VPS, make sure all installation and line connections have
been done as described in Section 2.
The calls to the VPS can be processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
Installation Manual 103