Panasonic KX-TVS95 Installation Manual page 36

2.5 INSTALLATION STEPS
CAUTION
If the DIP Switch is not reset to position 0 after initialization, all programming will
be lost when the voice processor loses power!
5.
Perform Quick Setup (see Section 5 CUSTOMIZING THE SYSTEM).
6.
Check Quick Setup:
•
•
If you do not see the "On Line" message, check the following:
•
•
•
•
•
7.
Set up Class of Service (COS) for each user. Customize voice prompts if necessary (see
Appendix B SYSTEM ADMINISTRATOR'S GUIDE).
8.
Perform Administrative Program through a personal computer (see Appendix B SYSTEM
ADMINISTRATOR'S GUIDE).
CAUTION
Do not turn the power off while the VPS is activated so as not to cause
malfunction.To turn the power off after installing the VPS, unplug the
power cord from the VPS a few minutes after disconnecting station wire(s).
36 Installation Manual
The Power Indicator on the Voice Processor should be solid.
The screen output should be: [On Line].
The line cord to the Voice Processor has 4 conductors.
The programming on the KX-TA624 is correctly set in System Program [130], or
[130] and [131].
The programming on the KX-TD816, KX-TD1232, KX-TA1232 or KX-TD308 is
correctly set in System Program [117].
The programming on the KX-TD500 is correctly set in the "1-4 VPS (DPT) Port
Assignment" screen.
The programming on the KX-TDA/KX-TAW series is correctly set in the
"3.Groups-7.VM(DPT) Group-2.Unit Setting" and "1.Configuration-8.Extension
Port" screens.