Table of Contents
Advertisement
Table B-32
Parameter
Message
Waiting
Lamp for
Every
Message
Max. Digits
for Callback
No.
Callback No.
Entry
Interdigit
Time-Out
System
Callback No.
B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS
Value Range
(Default)
1. No
If set to "Yes", the VPS will turn on the Message Waiting
2. Yes
Lamp of the extension each time a new message is
(Yes)
recorded in the mailbox. This will occur even if the
Message Waiting Lamp was not turned off from a
previous message. This setting is useful when the first
attempt is unsuccessful.
If set to "No", the VPS will turn on the Message Waiting
Lamp for the first message only. The VPS will not turn on
the lamp for subsequent messages until the subscriber
has accessed the VPS to retrieve the messages stored
there.
1-48 digits
Specifies the maximum number of digits the caller can
(20)
enter as a callback number. This number will display on
beepers if the "Beeper Callback No. Entry Mode" is
enabled.
1-10 s
Sets the maximum allowable time between each digit on
(5)
Beeper Callback No. Entry. If the caller does not enter any
digits within the specified time, the VPS will not accept
entry of any additional digits.
Up to 32 digits
Specifies a telephone number that will display on the
(None)
subscriber's beeper as a callback number. The callback
number entry mode "X" must be included in the telephone
number.
Note
If "Beeper Callback No. Entry Mode" is enabled
through COS, the callback number entered by the
caller will display on the destination beeper.
However, if the caller fails to enter a callback number,
the System Callback No. will display instead.
Description/Function
Installation Manual
317
Advertisement
Table of Contents
Troubleshooting
