Panasonic KX-TVS95 Installation Manual page 102

4.4 KX-TDA/KX-TAW SERIES PROGRAMMING FOR DIGITAL INTEGRATION
2.
Assignment of VM (DPT) extension ports
a)
Go to the "1.Configuration-8.Extension Port" screen. Follow the procedure below
for the extension port which you want to assign as a VM port.
b)
Select the attribute of "DPT Property-Type" to "VM (DPT)".
c)
Assign "DPT Property-VM Unit No." and "DPT Property-VM Port No.". Incoming
calls will hunt starting at the lowest VM Port number.
d)
Click "Apply" to save the changed data.
Notes
•
•
3.
To set for the trunk features, follow the instructions in "Step 2 Settings for the trunk
(outside line) features" in 3.3.8 KX-TDA/KX-TAW series Programming for Inband
Integration.
4.
Setting for Intercept Routing to a Mailbox of the VPS.
Callers' messages can be recorded as soon as calls (intercom calls and
incoming calls for an Incoming Call Distribution Group) are intercepted by the
VPS, by following the steps below:
a)
Go to the "3.Groups-7.VM(DPT) Group-1.System Setting" screen.
b)
Assign "Intercept to VM Sequence" to "Answer by Mailbox".
c)
Click "Apply" to save the changed data.
102 Installation Manual
Screen output:
The above screen output is an example of the KX-TDA200.
With DPT Integration, Port 1 of the KX-TVS95 is to be connected to the PBX,
allowing for a maximum of 2 Voice Mail extensions. Therefore, there is no benefit
to assigning more than one VM (DPT) extension port per KX-TVS95.