Panasonic KX-TVS95 Installation Manual page 152

5.2 PORT SETTING OPTIONS
Disconnect Parameter (1-5-8-9)
Determines how many seconds of silence the VPS allows during a caller's message before
disconnecting the call.
RS-232C Settings (1-6-1)
Allows the System Administrator to change the baud rate, parity bit, etc.
Port Setting (1-6-2)
Only to be used when connecting the VPS to a PBX other than a KX-T series PBX. Use the
CPC control of the PBX for normal disconnect problems.
Dialing Parameters (1-6-3-1)
These parameters are set automatically when Quick Setup is conducted.
Most of the settings will be left unchanged. The only setting that will be changed quite often is
the Transfer Sequence for the operator or the extension. By default, it is set at FXA on APT/
DPT Integration and FTXA for Inband Integration. In other words, the voice processor dials the
flash, waits for intercom tone and dials the extension number. By default, the VPS will stay on
the line to monitor the status of the call. If the extension user answers, the voice processor will
announce "you have a call" prior to releasing the call. This can be alleviated by adding the
letter "A" or "D" to the sequence. "A" stands for answer; the call will be transferred without the
announcement "you have a call". For a blind or unscreened transfer, add the letter "D" for
disconnect.
152 Installation Manual