Panasonic KX-TVS95 Installation Manual page 116

4.5 CONNECTING THE VPS WITH THE PANASONIC KX-TD816, KX-TD1232, KX-TA1232 AND KX-TD308
8.
Disconnect the power from the VPS and set the DIP Switch to position 5.
Only perform this step when initially setting up the system.
CAUTION
Setting the DIP Switch to position 5 will default the Voice Processing System,
resulting in a loss of all user programming and voice messages (except User 1 and
User 2 prompts).
9.
Plug in and power up the VPS and wait approximately 2.5 min while the system
initializes.
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2 INSTALLATION.
The calls to the VPS can be processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
•
•
•
Screen output:
Checking Flash Memory Cards.
Please wait...
PORT TEST...
SYSTEM SETUP
1... 2... 3... 4... 5... 6... 7... 8... 9...
•
•
Screen output:
Active COs: 1 2
DPT Interface Connection is Established
** ON LINE MODE **
The display will alert you if System Setup is not completed successfully.
Screen output:
Active COs: 1 2
DPT Interface Connection is not Established
** OFF LINE MODE **
This message will appear when the DPT connection between the VPS and telephone
system cannot be established.
Possible causes of the message: "DPT Interface Connection is not
Established"
116 Installation Manual
The Power Indicator light goes on.
The Power Indicator light begins to flash.
"Checking Flash Memory Cards" is displayed on the screen.
The VPS tests the CPU card, the flash memory, and the ports until
"1...2...3...4...5...6...7...8...9..." is displayed.
Active ports are displayed on the screen.