Table of Contents
Advertisement
4.6 DIGITAL INTEGRATION FEATURES AND SETUP PROCEDURES FOR THE PANASONIC KX-TA624, KX-
4.6.11 Voice Mail Transfer Button Assignment via Station
Programming
This feature allows an extension user to transfer calls directly to a Voice Mailbox. This is
available with both Digital and Inband Integrations.
PC programming is also available for KX-TD500 users (see 4.6.12 Button Assignment via PC
Programming).
1.
Enter PITS Programming:
For KX-TA624
With the phone on-hook, Set the MEMORY switch to "PROGRAM".
(Display changes to PITS-PGM Mode.)
For KX-T series PBX that uses DPT Integration
a. With the phone on-hook, Press the PROGRAM button.
b. Dial [99]. (Display changes to PITS-PGM Mode.)
2.
Press the desired Flexible (CO or DSS/BLF) button that you want to assign as the VTR
button.
3.
Dial [94] (for KX-TA624) or [8] (for KX-T series PBX that uses DPT Integration).
Screen output: VTR
4.
Dial the Voice Mail extension number.
Screen output: VTR-_ _ _
(_ _ _ = The extension number you entered).
5.
Press STORE.
6.
For KX-TA624
Set the MEMORY switch to "SET" .
For KX-T series PBX that uses DPT Integration
Press the PROGRAM button or lift the handset.
7.
Repeat these steps for each telephone.
Conditions:
4.6.12 Button Assignment via PC Programming
The KX-TD500 users can assign buttons via PC programming. Follow the procedure below to
assign each button.
1.
Go to "4-2 Extension Line" screen (refer to the screen image in 4.6.6 Live Call
Screening Assignment via PC Programming).
2.
Select the "Card No." and "Port No." which you are going to program.
126
Installation Manual
This button must be a CO or DSS/BLF key to be
programmed as a VTR button. When all Voice Mail
ports are busy and this key is pressed, the user will
hear reorder tone.
Advertisement
Table of Contents
Troubleshooting
