12 System Command; Esc+Cs Print Speed - SATO CL4NX Programming Reference Manual

12 System Command

12.1 System
12.1

ESC+CS Print Speed

Print Speed
ESC
Hexadecimal
code
<1B>
16
Initial value Refer to the table below.
When the power switch is OFF
Valid range and
term of Valid range within items
command
Valid range between items
[Function]
Specifying the speed of printing.
[Format]
<CS>aa
●Parameter
a [Print speed] = Refer to the table below
[Coding Example]
<A>
<CS>4
<Z>
[Supplementary Explanation]
Print darkness value specified by the command or LCD is maintained.
[Notes]
1. If the value over valid range is specified, command error will occur and print speed will not be changed.
2. Use default set operation of the printer to set back the value to the initial one.
[Parameter Initial Value and Specified Range]
Head density Initial value [aa]
8dots/mm
(203dpi)
12dots/mm
(305dpi)
24dots/mm
(609dpi)
CS
<43> <53>
16 16
Parameter Valid Range
6 2, 3, 4, 5, 6, 7, 8, 9, 10
6 2, 3, 4, 5, 6, 7, 8
4 2, 3, 4, 5, 6
240
ESC+CS
Parameter
aa
The set parameter is maintained.
The set parameter is valid until the next valid setting.
The set parameter is valid until the next valid setting.
Print speed corresponding to parameter
2: 2(inch/s) 50.8 (mm/s)
3: 3(inch/s) 76.2 (mm/s)
4: 4(inch/s) 101.6 (mm/s)
5: 5(inch/s) 127.0 (mm/s)
6: 6(inch/s) 152.4 (mm/s)
7: 7(inch/s) 177.8 (mm/s)
8: 8(inch/s) 203.2 (mm/s)
9: 9(inch/s) 228.6 (mm/s)
10: 10(inch/s) 254.0 (mm/s)