Load Sharing Mode Of An Aggregation Group; Configuring Link Aggregation And Lacp; Configuration Task List - HP V1910 Switch Series User Manual

state. At the same time, the peer device, being aware of the changes, changes the state of its
ports accordingly.
Set the ports that cannot aggregate with the reference port to the Unselected state.
2.
NOTE:
For static and dynamic aggregation modes:
In an aggregation group, the port to be a selected port must be the same as the reference port in port
attributes, and class-two configurations. To keep these configurations consistent, you should manually
configure the port.
Change a port attribute or class-two configuration setting for a port with caution, because the change
may affect the aggregation state of member ports and interrupt services.

Load sharing mode of an aggregation group

Every link aggregation group created on HP V1910 Switch Series operates in load sharing mode all the
time, even when it contains only one member port.

Configuring link aggregation and LACP

Configuration task list

Configuring a static aggregation group
Perform the tasks in
Table 81 Static aggregation group configuration task list
Task
Creating a link aggregation group
Displaying information of an aggregate
interface
Configuring a dynamic aggregation group
Perform the tasks in
Table 81 to configure a static aggregation group.
Table 82 to configure a dynamic aggregation group.
Remarks
Required
Create a static aggregate interface and configure member
ports for the static aggregation group automatically created
by the system when you create the aggregate interface.
By default, no link aggregation group exists.
Optional
Perform this task to view detailed information of an existing
aggregation group.
203