HP V1910 Switch Series User Manual page 172

Figure 142 Configure the voice VLAN function globally
Select Enable in the Voice VLAN security drop-down list. You can skip this step, because the voice

VLAN security mode is enabled by default.
Set the voice VLAN aging timer to 30 minutes.

Click Apply.

# Configure voice VLAN on GigabitEthernet 1/0/1.
Click the Port Setup tab to enter the page shown in

Figure 143 Configure voice VLAN on GigabitEthernet 1/0/1
Select Auto in the Voice VLAN port mode drop-down list.

Select Enable in the Voice VLAN port state drop-down list.

Type voice VLAN ID 2.

 Select GigabitEthernet 1/0/1 on the chassis front panel.
Click Apply.

# Add OUI addresses to the OUI list.
Click the OUI Add tab to enter the page shown in

Figure 143.
Figure 144.
158