Configuration Guidelines - HP V1910 Switch Series User Manual

 After the configuration process is complete, click Close.
# Assign GigabitEthernet 1/0/1 to VLAN 2 and VLANs 6 through 50 as a tagged member.
Click Modify Port to enter the page for modifying the VLANs to which a port belongs, as shown in
133.
Figure 133 Assign GigabitEthernet 1/0/1 to VLAN 2 and VLANs 6 through 50 as a tagged member
 Select GigabitEthernet 1/0/1 on the chassis front device panel.
Select the Tagged option in the Select membership type area.

Type VLAN IDs 2, 6-50.

 Click Apply. A configuration progress dialog box appears.
After the configuration process is complete, click Close in the dialog box.

Configure Switch B
2.
Configure Switch B as you configure Switch A.

Configuration guidelines

When configuring the VLAN function, follow these guidelines:
As the default VLAN, VLAN 1 cannot be created or removed.

 You cannot create or remove VLANs reserved for special purposes.
Dynamic VLANs cannot be removed on the page for removing VLANs.

You cannot remove a VLAN that has referenced a QoS policy.

To remove a remote probe VLAN for remote port mirroring, you must remove the remote probe

VLAN configuration first.
145
Figure