Creating A Static Arp Entry; Static Arp Configuration Example - HP V1910 Switch Series User Manual

Creating a static ARP entry

Select Network > ARP Management from the navigation tree to enter the default ARP Table page shown
in Figure 267. Click Add to enter the New Static ARP Entry page. Select the Advanced Options checkbox
to expand advanced configuration items, as shown in
Figure 268 Add a static ARP entry
Table 1 14 describes the static ARP entry configuration items.
Table 114 Static ARP entry configuration items
Item
IP Address
MAC Address
Advanced
Options

Static ARP configuration example

Network requirements
As shown in
interface GigabitEthernet 1/0/1 belonging to VLAN 100. The IP address of Router B is 192.168.1.1/24.
The MAC address of Router B is 00e0-fc01-0000.
To enhance communication security between Switch A and Router B, static ARP entries need to be
configured on Switch A.
Description
Type an IP address for the static ARP entry.
Type a MAC address for the static ARP entry.
Type a VLAN ID and specify a port for the static ARP entry.
VLAN ID
IMPORTANT:
The VLAN ID must be the ID of the VLAN that has already been created, and the port
Port
must belong to the VLAN. The corresponding VLAN interface must have been created.
Figure 269, hosts are connected to Switch A, which is connected to Router B through
Figure 268.
301