Qos Configuration; Configuration Task Lists - HP V1910 Switch Series User Manual

Input DSCP value
16 to 23
24 to 31
32 to 39
40 to 47
48 to 55
56 to 63
NOTE:
In the default DSCP to DSCP mapping table, an input value yields a target value equal to it.

QoS configuration

Configuration task lists

Configuring a QoS policy
A QoS policy defines the shaping, policing, or other QoS actions to take on different classes of traffic.
It is a set of class-behavior associations.
A class is a set of match criteria for identifying traffic, and it uses the AND or OR operator:
If the operator is AND, a packet must match all the criteria to match the class.

If the operator is OR, a packet matches the class if it matches any of the criteria in the class.

A traffic behavior defines a set of QoS actions to take on packets, such as priority marking and redirect.
By associating a traffic behavior with a class in a QoS policy, you apply the specific set of QoS actions
to the class of traffic. You can apply a QoS policy to a port to regulate the incoming traffic of the port.
A QoS policy can be applied to multiple ports. Only one policy can be applied in inbound direction of
a port.
Perform the tasks in
Table 158 QoS policy configuration task list
Task
Configure a
class
Local precedence (Queue)
2
3
4
5
6
7
Table 158 to configure a QoS policy:
Creating a class
Configuring match criteria
Remarks
Required
Create a class and specify the operator for
the match criteria in the class.
Required
Configure match criteria for the class.
423
CoS
2
3
4
5
6
7