Creating An Ipv4 Static Route - HP V1910 Switch Series User Manual

Creating an IPv4 static route

Select Network > IPv4 Routing from the navigation tree and click the Create tab to enter the IPv4 static
route configuration page, as shown in
Figure 227 Create an IPv4 static route
Table 105 IPv4 static route configuration items
Item
Destination IP Address
Mask
Preference
Next Hop
Interface
Figure 227.
Description
Type the destination IP address of the static route, in dotted decimal notation.
Specify the mask of the destination IP address.
Select a mask length (number of consecutive 1s in the mask) or a mask in
dotted decimal notation from the drop-down list.
Type a preference value for the static route. The smaller the number, the higher
the preference.
For example, specifying the same preference for multiple static routes to the
same destination enables load sharing on the routes; specifying different
preferences enables route backup.
Type the next hop IP address, in dotted decimal notation.
Select the output interface.
You can select any available interface, for example, a virtual interface, of the
device. If you select NULL 0, the destination IP address is unreachable.
261