To Disconnect The Expansion Unit Cables; Disconnecting The Cables; Removing The Expansion Unit - Nortel BCM50 3.0 Installation And Maintenance Manual

188 Chapter 23 Replacing an expansion unit
For information about replacing an expansion unit:
•

Disconnecting the cables

•

Removing the expansion unit

• Removing the MBM
• Inserting the MBM in the new expansion unit
• Installing the new expansion unit
Disconnecting the cables
Use the following procedure to disconnect the expansion unit from the other equipment.

To disconnect the expansion unit cables

1 Use Element Manager to disable the media bay module (MBM) that is installed in the
expansion unit. For more information, see the Administration Guide.
2 Disconnect the expansion cable from the expansion port on the expansion unit.
3 Disconnect the LAN cable from the LAN port on the expansion unit.
4
Disconnect all of the telephone lines and extension cables from the MBM inserted in the
expansion unit.
If more than one cable exists, mark the cables to identify the port from which you removed
them.
5 Rotate the power supply retention clip to free the power supply cord.
6
Remove the power supply cord from the expansion unit.
Warning: Leakage currents
You must disconnect the telephony and data networking cables from the system before
disconnecting the power cord from a grounded outlet.
7 Proceed to
Removing the expansion unit
How you remove the expansion unit depends on how the unit is mounted. Use one of the following
procedures to remove the expansion unit:
• To remove a rack-mounted expansion unit
• To remove a wall-mounted expansion unit
• To remove a desktop-mounted expansion unit
NN40020-302
on page 188
on page 188
on page 190
on page 191
Removing the expansion unit
on page 190
on page 188.
on page 189
on page 189
on page 189