Next Step - Nortel BCM50 3.0 Installation And Maintenance Manual

If an error occurs, the status LED flashes red. View the log file (written to the USB storage
device) for a description of the Startup Profile errors. If no errors exist, the BCM50 system
automatically reboots to complete the system configuration. After the reboot finishes, the
power and status LEDs are solid green.
Note: The Startup Profile works only on a BCM50 system with no keycode
loaded. After a keycode is loaded, the Startup Profile does not work. This
condition prevents unintentional overwriting of the parameters of a configured
system.
4 Remove the USB storage device from the USB port on the BCM50 or the USB hub.
Note: Make sure the bootup sequence is complete before removing the USB
storage device from the BCM50 system.
5
Connect the 25-pair cable to the RJ-21 telephony connector on the BCM50 main unit.
The Startup Profile is now loaded on your BCM50 system.

Next step

After you load the Startup Profile, you can connect the data networking cables. For information
about connecting these cables, see
Chapter 15 Using the Startup Profile to configure parameters
Completing the initial installation (optional) on page 155.
Installation and Maintenance Guide
153