Nortel BCM50 3.0 Installation And Maintenance Manual page 143

Click Launch Router WebGUI tool to launch the router configuration tool.
For information about using the router WebGUI tool, see the Integrated Router
Configuration Guide for your product.
• Clear the Use DHCP Server on Integrated Router check box to use the DHCP server on
the main unit. You must first disable the DHCP server on the integrated router using the
router WebGUI tool.
For information about using the router WebGUI tool, see the Integrated Router
Configuration Guide for your product.
5 Configure the attributes according to the table
page 143.
Table 26 DHCP Server: General Settings attributes
Attribute
Use DHCP Server on
Integrated Router
DHCP server is
IP domain name
Primary DNS IP address
Secondary DNS IP address Specify the IP addresses of the secondary DNS server in a valid dot format.
WINS server address
WINS node type
Default gateway
Lease time
Chapter 14 Using Element Manager to set the basic parameters
Description
Note: This attribute is available only on main units with an integrated router
(BCM50a, BCM50e, BCM50ba, BCM50be).
Specify whether or not to use the DHCP server on the integrated router.
If selected, the DHCP server on the integrated router is used, and the DHCP
server on the main unit is disabled.
If cleared, the DHCP server on the main unit is active. You must first disable
the DHCP server on the integrated router to avoid networking conflicts.
Select either enable or disable from the list.
The domain name of the network.
Specify the IP addresses of the primary DNS server in a valid dot format.
BCM50 automatically assigns the value for this parameter. If the IP address or
subnet mask for the corresponding LAN interface changes, this value is
overwritten. Use caution when changing this value.
BCM50 automatically assigns the value for this parameter. If the IP address or
subnet mask for the corresponding LAN interface changes, this value is
overwritten. Use caution when changing this value.
Specify the IP address of the WINS server.
BCM50 automatically assigns the value for this parameter. If the IP address or
subnet mask for the corresponding LAN interface changes, this value is
overwritten. Use caution when changing this value.
Specify a client WINS node type.
The BCM50 system automatically sets this value to H-node on all DHCP
clients. This setting configures the DHCP client PCs to use P-node name
resolution before resorting to B-node name resolution.
Note: Use caution if you change this attribute.
Specify the IP address of the default next-hop router.
BCM50 automatically assigns the value for this parameter. If the IP address or
subnet mask for the corresponding LAN interface changes, this value is
overwritten. Use caution when changing this value.
Specify the time, in seconds, for an address assignment until the client lease
expires.
The default is 259 200 seconds (72 hours).
DHCP Server: General Settings attributes
Installation and Maintenance Guide
143
on