Figure 34-7 Menu 21.1.X.1 Tcp/Ip Filter Rule; Table 34-3 Menu 21.1.X.1 Tcp/Ip Filter Rule - ZyXEL Communications Prestige 652H series User Manual

Prestige 652H/HW Series User's Guide
Press Space Bar to Toggle.
The following table describes how to configure your TCP/IP filter rule.
FIELD
Filter #
Filter Type
Active
IP Protocol
IP Source Route
Destination:
34-8
Menu 21.1.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= No
IP Protocol= 0
Destination: IP Addr=
Source: IP Addr=
TCP Estab= N/A
More= No
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:

Figure 34-7 Menu 21.1.x.1 TCP/IP Filter Rule

Table 34-3 Menu 21.1.x.1 TCP/IP Filter Rule

This is the filter set, filter rule coordinates, for instance, 2, 3
refers to the second filter set and the third filter rule of that
set.
Use [SPACE BAR] and then [ENTER] to choose a rule.
Parameters displayed for each type will be different. Choices
are TCP/IP Filter Rule or Generic Filter Rule.
Select Yes to activate or No to deactivate the filter rule.
This is the upper layer protocol, for example, TCP is 6, UDP
is 17 and ICMP is 1. The value must be between 0 and 255.
A value of O matches ANY protocol.
IP Source Route is an optional header that dictates the route
an IP packet takes from its source to its destination. If Yes,
the rule applies to any packet with an IP source route. The
majority of IP packets do not have source route.
IP Source Route= No
IP Mask=
Port #=
Port # Comp= None
IP Mask=
Port #=
Port # Comp= None
Log= None
DESCRIPTION EXAMPLE
1,1
TCP/IP Filter Rule
No
(default)
0 to 255
No
(default)
Filter Configuration