Advanced Wan Screen - ZyXEL Communications NBG6515 User Manual

Table 51 Network > WAN > Internet Connection: PPPoE Encapsulation (continued)
L ABEL
First DNS Server
Second DNS
Server
WAN MAC
Address
Factory default
Clone the
computer's MAC
address - IP
Address
Set WAN MAC
Address
Apply
Reset
13.5 Adva nc e d WAN Sc re e n
Use this screen to enable
Note: The categories shown in this screen are independent of each other.
To change your NBG's advanced WAN settings, click
as shown.
Network > WAN > Advanced
Fig ure 77
Chapter 13 WAN
DESC RIPT IO N
Select if your ISP dynamically assigns DNS server information (and the NBG's WAN IP
Fro m ISP
address). The field to the right displays the (read-only) DNS server IP address that the ISP
assigns.
Select if you have the IP address of a DNS server. Enter the DNS server's IP address
Use r- De fine d
in the field to the right. If you chose
changes to after you click
De fine d No ne
and enter the same IP address, the second
.
Apply
Select if you do not want to configure DNS servers. If you do not configure a DNS server,
No ne
you must know the IP address of a computer in order to access it.
The MAC address section allows users to configure the WAN port's MAC address by using the
NBG's MAC address, copying the MAC address from a computer on your LAN or manually
entering a MAC address.
Select to use the factory assigned default MAC Address.
Fa c to ry de fa ult
Select
C lo ne the c o m pute r's MAC a ddre ss - IP Addre ss
computer on the LAN whose MAC you are cloning.
Select this option and enter the MAC address you want to use.
Click to save your changes back to the NBG.
Apply
Click to begin configuring this screen afresh.
Re se t
.
Multic a st
NBG6515 User's Guide
105
, but leave the IP address set to 0.0.0.0,
Use r- De fine d
. If you set a second choice to
Apply
changes to
Use r- De fine d
and enter the IP address of the
> >
Ne two rk WAN Adva nc e d
Use r-
,
Use r- De fine d
after you click
No ne
. The screen appears