Language Screen; Ipv6 Screen - ZyXEL Communications 310 User Manual

Table 191 Configuration > System > SNMP (continued)
LABEL
#
Zone
Address
Action
Apply
Reset

37.12 Language Screen

Click Configuration > System > Language to open the following screen. Use this screen to
select a display language for the ZyWALL's Web Configurator screens.
Figure 334 Configuration > System > Language
The following table describes the labels in this screen.
Table 192 Configuration > System > Language
LABEL
Language Setting
Apply
Reset

37.13 IPv6 Screen

Click Configuration > System > IPv6 to open the following screen. Use this screen to enable
IPv6 support for the ZyWALL's Web Configurator screens. See the
more information about IPv6.
ZyWALL 110/310/1100 Series User's Guide
DESCRIPTION
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL's (non-configurable) default
policy. The ZyWALL applies this to traffic that does not match any other configured rule. It
is not an editable rule. To apply other behavior, configure a rule that traffic will match so
the ZyWALL will not have to use the default policy.
This is the zone on the ZyWALL the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is allowed or denied
to access.
This displays whether the computer with the IP address specified above can access the
ZyWALL zone(s) configured in the Zone field (Accept) or not (Deny).
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
DESCRIPTION
Select a display language for the ZyWALL's Web Configurator screens. You also need
to open a new browser session to display the screens in the new language.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Chapter 37 System
IPv6 Overview on page 106 for
483