Ipv6 Address Add/Edit Screen - ZyXEL Communications 310 User Manual

Table 142 IPv4 Address Configuration > Add/Edit (continued)
LABEL
OK
Cancel

28.2.2 IPv6 Address Add/Edit Screen

The Configuration > IPv6 Address Add/Edit screen allows you to create a new address or edit
an existing one. To access this screen, go to the Address screen (see
and click either the Add icon or an Edit icon in the IPv6 Address Configuration section.
Figure 253 IPv6 Address Configuration > Add/Edit
The following table describes the labels in this screen.
Table 143 IPv6 Address Configuration > Add/Edit
LABEL
Name
Object Type
IPv6 Address
IPv6 Starting
Address
IPv6 Ending
Address
IPv6 Address
Prefix
Interface
IPv6 Address
Type
OK
Cancel
ZyWALL 110/310/1100 Series User's Guide
DESCRIPTION
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving your changes.
DESCRIPTION
Type the name used to refer to the address. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is
_
case-sensitive.
Select the type of address you want to create. Choices are: HOST, RANGE, SUBNET,
INTERFACE IP, INTERFACE SUBNET, and INTERFACE GATEWAY.
Note: The ZyWALL automatically updates address objects that are based on an interface's
IP address, subnet, or gateway if the interface's IP address settings change. For
example, if you change 1's IP address, the ZyWALL automatically updates the
corresponding interface-based, LAN subnet address object.
This field is only available if the Address Type is HOST. This field cannot be blank. Enter
the IP address that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the beginning of the range of IP addresses that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the end of the range of IP address that this address object represents.
This field is only available if the Address Type is SUBNET. This field cannot be blank.
Enter the IPv6 address prefix that the ZyWALL uses for the LAN IPv6 address.
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the
Address Type, use this field to select the interface of the network that this address object
represents.
Select whether the IPv6 address is a link-local IP address (LINK LOCAL), static IP
address (STATIC), an IPv6 StateLess Address Auto Configuration IP address (SLAAC), or
is obtained from a DHCPv6 server (DHCPv6).
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving your changes.
Chapter 28 Addresses
Section 28.2 on page 384),
387