Ipv4 Address Add/Edit Screen - ZyXEL Communications 310 User Manual

Chapter 28 Addresses
Table 141 Configuration > Object > Address > Address (continued)
LABEL
Type
IPv6 Address

28.2.1 IPv4 Address Add/Edit Screen

The Configuration > IPv4 Address Add/Edit screen allows you to create a new address or edit
an existing one. To access this screen, go to the Address screen (see
and click either the Add icon or an Edit icon in the IPv4 Address Configuration section.
Figure 252 IPv4 Address Configuration > Add/Edit
The following table describes the labels in this screen.
Table 142 IPv4 Address Configuration > Add/Edit
LABEL
Name
Address Type
IP Address
Starting IP
Address
Ending IP
Address
Network
Netmask
Interface
386
DESCRIPTION
This field displays the type of each address object. "INTERFACE" means the object uses
the settings of one of the ZyWALL's interfaces.
This field displays the IPv6 addresses represented by each address object. If the object's
settings are based on one of the ZyWALL's interfaces, the name of the interface displays
first followed by the object's current address settings.
DESCRIPTION
Type the name used to refer to the address. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is
_
case-sensitive.
Select the type of address you want to create. Choices are: HOST, RANGE, SUBNET,
INTERFACE IP, INTERFACE SUBNET, and INTERFACE GATEWAY.
Note: The ZyWALL automatically updates address objects that are based on an interface's
IP address, subnet, or gateway if the interface's IP address settings change. For
example, if you change 1's IP address, the ZyWALL automatically updates the
corresponding interface-based, LAN subnet address object.
This field is only available if the Address Type is HOST. This field cannot be blank. Enter
the IP address that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the beginning of the range of IP addresses that this address object represents.
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the end of the range of IP address that this address object represents.
This field is only available if the Address Type is SUBNET, in which case this field cannot
be blank. Enter the IP address of the network that this address object represents.
This field is only available if the Address Type is SUBNET, in which case this field cannot
be blank. Enter the subnet mask of the network that this address object represents. Use
dotted decimal format.
If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the
Address Type, use this field to select the interface of the network that this address object
represents.
Section 28.2 on page
ZyWALL 110/310/1100 Series User's Guide
384),