ZyXEL Communications 310 User Manual page 431

Table 167 Configuration > Object > ISP Account > Edit (continued)
LABEL
Authentication
Type
Encryption
Method
User Name
Password
Retype to
Confirm
Server IP
Connection ID
Service Name
Compression
Idle Timeout
OK
Cancel
ZyWALL 110/310/1100 Series User's Guide
DESCRIPTION
Use the drop-down list box to select an authentication protocol for outgoing calls. Options
are:
CHAP/PAP - Your ZyWALL accepts either CHAP or PAP when requested by this remote
node.
Chap - Your ZyWALL accepts CHAP only.
PAP - Your ZyWALL accepts PAP only.
MSCHAP - Your ZyWALL accepts MSCHAP only.
MSCHAP-V2 - Your ZyWALL accepts MSCHAP-V2 only.
This field is available if this ISP account uses the PPTP protocol. Use the drop-down list
box to select the type of Microsoft Point-to-Point Encryption (MPPE). Options are:
nomppe - This ISP account does not use MPPE.
mppe-40 - This ISP account uses 40-bit MPPE.
mppe-128 - This ISP account uses 128-bit MMPE.
Type the user name given to you by your ISP.
Type the password associated with the user name above. The password can only consist of
alphanumeric characters (A-Z, a-z, 0-9). This field can be blank.
Type your password again to make sure that you have entered is correctly.
If this ISP account uses the PPPoE protocol, this field is not displayed.
If this ISP account uses the PPTP protocol, type the IP address of the PPTP server.
This field is available if this ISP account uses the PPTP protocol. Type your identification
name for the PPTP server. This field can be blank.
If this ISP account uses the PPPoE protocol, type the PPPoE service name to access. PPPoE
uses the specified service name to identify and reach the PPPoE server. This field can be
blank.
If this ISP account uses the PPTP protocol, this field is not displayed.
Select On button to turn on stac compression, and select Off to turn off stac compression.
Stac compression is a data compression technique capable of compressing data by a factor
of about four.
This value specifies the number of seconds that must elapse without outbound traffic
before the ZyWALL automatically disconnects from the PPPoE/PPTP server. This value must
be an integer between 0 and 360. If this value is zero, this timeout is disabled.
Click OK to save your changes back to the ZyWALL. If there are no errors, the program
returns to the ISP Account screen. If there are errors, a message box explains the error,
and the program stays in the ISP Account Edit screen.
Click Cancel to return to the ISP Account screen without creating the profile (if it is new)
or saving any changes to the profile (if it already exists).
Chapter 34 ISP Accounts
431