ZyXEL Communications 310 User Manual page 161

Figure 96 Configuration > Network > Interface > Bridge
Each field is described in the following table.
Table 57 Configuration > Network > Interface > Bridge
LABEL
Configuration / IPv6
Configuration
Add
Edit
Remove
Activate
Inactivate
Create Virtual
Interface
Object References
#
Status
Name
IP Address
Member
Apply
Reset
ZyWALL 110/310/1100 Series User's Guide
DESCRIPTION
Use the Configuration section for IPv4 network settings. Use the IPv6
Configuration section for IPv6 network settings if you connect your ZyWALL to an
IPv6 network. Both sections have similar fields as described below.
Click this to create a new entry.
Double-click an entry or select it and click Edit to open a screen where you can modify
the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms you want to
remove it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
To open the screen where you can create a virtual interface, select an interface and
click Create Virtual Interface.
Select an entry and click Object Reference to open a screen that shows which
settings use the entry. See
This field is a sequential value, and it is not associated with any interface.
This icon is lit when the entry is active and dimmed when the entry is inactive.
This field displays the name of the interface.
This field displays the current IP address of the interface. If the IP address is 0.0.0.0,
the interface does not have an IP address yet.
This screen also shows whether the IP address is a static IP address (STATIC) or
dynamically assigned (DHCP). IP addresses are always static in virtual interfaces.
This field displays the Ethernet interfaces and VLAN interfaces in the bridge interface.
It is blank for virtual interfaces.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Section 7.3.2 on page 122
Chapter 7 Interfaces
for an example.
161