ZyXEL Communications 310 User Manual page 146

Chapter 7 Interfaces
Table 51 Network > Interface > Tunnel > Add/Edit (continued)
LABEL
Interface
Parameters
Egress
Bandwidth
Ingress
Bandwidth
MTU
Connectivity Check
Enable
Connectivity
Check
Check Method
Check Period
Check Timeout
Check Fail
Tolerance
Check Default
Gateway
Check this
address
Check Port
Related Setting
WAN TRUNK
Policy Route
OK
Cancel
146
DESCRIPTION
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can send
through the interface to the network. Allowed values are 0 - 1048576. This setting is
used in WAN load balancing and bandwidth management.
This is reserved for future use.
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can receive
from the network through the interface. Allowed values are 0 - 1048576.
Maximum Transmission Unit. Type the maximum size of each data packet, in bytes,
that can move through this interface. If a larger packet arrives, the ZyWALL divides it
into smaller fragments. Allowed values are 576 - 1500. Usually, this value is 1500.
This section is available if you are configuring a GRE tunnel.
The interface can regularly check the connection to the gateway you specified to make
sure it is still available. You specify how often the interface checks the connection, how
long to wait for a response before the attempt is a failure, and how many consecutive
failures are required before the ZyWALL stops routing to the gateway. The ZyWALL
resumes routing to the gateway the first time the gateway passes the connectivity
check.
Select this to turn on the connection check.
Select the method that the gateway allows.
Select icmp to have the ZyWALL regularly ping the gateway you specify to make sure it
is still available.
Select tcp to have the ZyWALL regularly perform a TCP handshake with the gateway
you specify to make sure it is still available.
Enter the number of seconds between connection check attempts.
Enter the number of seconds to wait for a response before the attempt is a failure.
Enter the number of consecutive failures before the ZyWALL stops routing through the
gateway.
Select this to use the default gateway for the connectivity check.
Select this to specify a domain name or IP address for the connectivity check. Enter
that domain name or IP address in the field next to it.
This field displays when you set the Check Method to tcp. Specify the port number to
use for a TCP connectivity check.
Click this link to go to a screen where you can configure WAN trunk load balancing.
Click this link to go to the screen where you can manually configure a policy route to
associate traffic with this interface.
Click OK to save your changes back to the ZyWALL.
Click Cancel to exit this screen without saving.
ZyWALL 110/310/1100 Series User's Guide